Canadian Contractor
Video

How to do incredible onsite ‘millwork’ using handheld and table routers


Print this page

July 7, 2015 by Steve Payne

Our tools editor, Steve Maxwell, has just celebrated 250,000 views of this video on YouTube. No wonder: It’s terrific information. In under 3 minutes, Steve shows you how you can can do custom handrails, door and window trim, crown moulding, wainscoting – endless types of “millwork” – using a simple router and some attachments. As Steve says, this type of router usage by contractors, onsite, is not “typical.” But you don’t make as much money when you’re typical, do you?


Steve Payne

Steve Payne

Steve Payne is the editor of Canadian Contractor magazine
All posts by

Print this page



Related

Have your say:

Your email address will not be published. Required fields are marked *

*